Ford galaxy 2013 engine malfunction engine loosing power

[Emma Louise Eaton]

Hi
I am new to this so I would be really grateful for any help.
I have an automatic diesel ford galaxy 2013
Whilst driving, it suddenly becomes lumpy and eventually the engine malfunction light appears with the ABS light and then feels like I am fighting to get acceleration, or against breaking?
As I have children in the car this is beginning to bother me as we could be going 60 and without warning reduce speed.
I have taken it to a mechanic and had the temputure sensor changed then it started again so it went back and had it on the computer and rest it back to factory setting but itââ,¬â,,¢s doing it much more now. Any ideas? Thank you

[johnnyroper]

You need to get the fault codes it generates when faults occur ideally from engine and abs controllers,then you have an idea where to start.

[Emma Louise Eaton]

Hi many thanks unfortunately it threw up lots of different codes but donââ,¬â,,¢t know where to start with them all? I canââ,¬â,,¢t afford to try each one until it is the right one just thought someone might have had a similar problem. But thank you

[johnnyroper]

Post up the codes it threw up as there could well be a common link to them all

[gregers]

were the codes you found from the on board diagnostic check?
iirc i had some stored on my smax,they didnt seem to correspond with anything i found on line.
if the codes you have were through the proper ford diagnostic then do as above and post them up.

also iirc the alarm/central locking module needs to power down,so disconnect your battery for about 1/2 hr then run on board diag again,

MAKE sure you have your radio code before doing this.