Welcome to BigCarClub!

Site Notification:

BigCarClub is now closed to registrations. Whilst it remains available online, the site is now an archive only and will eventually expire.
Thank you to all our members who contributed over the years!

Not logged in!

Hey there, welcome to BigCarClub!
You don't need to be logged in to view the forum but the experience will be so much better if you are! Users can login or if you don't have an account already, you can create one for free by clicking the Register link in the top right corner of this page.

Advert:

Fitting new clutch advice

Started by Tony5496, September 04, 2015, 11:00:29 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down 1
User actions
September 04, 2015, 11:00:29 AM
Just going to have the clutch and fly wheel replace on my Ford Galaxy 2.0TDCI. does anybody know whether the driveshafts just unbolts each side or are they actually in the gearbox and need pulling out any help would be great many thanks
September 05, 2015, 12:05:28 PM #1
Most Fords I've seen and worked on tend to use driveshaft configurations that plug into the gearbox (where a sprung circlip retains them in a groove in the diff), the shafts that unbolt from a flange (which remains in the gearbox meaning you don't lose gearbox oil when you take the driveshafts off and the gearbox out) seem to be mainly a VW thing.
Always learning..... Often by mistakes!
User actions
Print
Go Up 1