Big Car Club - MPV and SUV Forums
MPV Section - Forums for Multi Purpose Vehicles: => Ford Galaxy Forum - Mk1 / Mk2 inc. VW Sharan and SEAT Alhambra (1995-2006) => Topic started by: Oceanlord8 on December 14, 2017, 12:32:18 PM
Has anyone used Steel Seal to cure a blown head gasket?
This is my first post.
The blown gasket is my own diagnosis based on coolant loss and the fact that the system is pressurised after a few minutes running.
Advice welcomed
Try it . It most probably wont work though. The 115s tend to suffer a lot of head gasket failures. I use the 150 bhp head bolts on head gasket replacements as they have a higher rating.
Sent from my SM-G930F using Tapatalk
Common problem caused by the heating and cooling cycles and head bolts unable to maintain head to block pressure.
Save your money the steel seal will not work,needs head off,head gasket set,timing belt kit and 150hp bolts.