Big Car Club - MPV and SUV Forums

MPV Section - Forums for Multi Purpose Vehicles: => Ford Galaxy Owners Forum - Mk3 Mk4 / Ford S-Max Mk1 Mk2 (2006-Present) => Topic started by: gibbo1977 on June 20, 2015, 02:41:22 PM

Title: turbo?
Post by: gibbo1977 on June 20, 2015, 02:41:22 PM
Hi guys i have an 07 1.8tdci galaxy. Was going up through the gears and heard a pop then a plume of black smoke from the exhaust! Car is in limp mode with engine malfunction light on. Has my turbo died??
Title: Re: turbo?
Post by: Chrispb on June 20, 2015, 03:07:16 PM
Hello and  welcome5

Sounds more like a hose has split on the air charge side.
Title: Re: turbo?
Post by: gibbo1977 on June 20, 2015, 07:37:14 PM
Hi Chris aye hopefully m8. Got codes p010f and p0299 the later points to a split hose when i googled them. Cheers
Title: Re: turbo?
Post by: gibbo1977 on June 20, 2015, 11:18:50 PM
Noticed this on the pipe
Title: Re: turbo?
Post by: insanitybeard on June 21, 2015, 12:04:16 AM
That'll do it, I don't know the plumbing layout well enough on the Mk3 to say if that hole should just be blanked off or if there is another pipe or a sensor that plugs in there.

Having said that, if this (http://eucatparts.com/?action=cat_ford_part&s_id_part=1191695&s_id_model=118&s_code_image=G015675802) is the correct parts diagram for your spec of vehicle it looks like it could be the port for the air temp sensor.
Title: Re: turbo?
Post by: gibbo1977 on June 21, 2015, 12:36:04 AM
hi Paul am not clued up on mechanics but I get the feeling there should be something in that hole lol... and there is quite a bit of oil around it too
Title: Re: turbo?
Post by: insanitybeard on June 21, 2015, 12:42:58 AM
If there was a sensor in there then it should still be floating about loose in the engine bay somewhere attached to a cable.
Title: Re: turbo?
Post by: gibbo1977 on June 21, 2015, 12:59:11 AM
arite I thought it would be gone.. i'll get a look tomorrow. do you think it be knackered or just needing put back in?
Title: Re: turbo?
Post by: insanitybeard on June 21, 2015, 01:06:15 AM
From the looks of it I'm guessing the plastic part that plugs that pipe (that the sensor itself would then fit into) is probably glued or bonded into place and this has failed, allowing the plug to blow out. Assuming there was a sensor in it then see if you can find the cable/ sensor and see what's still attached to it, I'd say it's unlikely you'll be able to just plug it back in though, more likely the pipe itself has failed and a new one will be required.
Title: Re: turbo?
Post by: Mirez on June 21, 2015, 06:51:40 PM
That's a mighty big hole for a sensor, I'm fairly sure the IAT sensor is the same as used on the Mondeo and Focus which would make it a lot smaller then that hole, unless its a plate that the sensor screws onto which kinda seems an odd choice.

What side of the engine is that pipe on? Trying to work out if its pre or post intercooler.
Title: Re: turbo?
Post by: gregers on June 21, 2015, 08:43:24 PM
any of this helpful at all?

http://eucatparts.com/?action=cat_ford_unit&s_id_grp=1191412&s_id_model=118
Title: Re: turbo?
Post by: gibbo1977 on June 27, 2015, 03:13:57 AM
Got a new pipe put on but they dont come with the air temp sensors anymore so it had to be remapped at a ford dealership which cost Ã,£40. All going well now thanks for all the comments