Big Car Club - MPV and SUV Forums
MPV Section - Forums for Multi Purpose Vehicles: => Ford Galaxy Owners Forum - Mk3 Mk4 / Ford S-Max Mk1 Mk2 (2006-Present) => Topic started by: madocks on June 06, 2015, 07:57:23 PM
Evening,
First post here, good forum :D
1) - Central locks doesnt work on rear, work on front but seem to be slow. When you lock they sometimes lock, sometimes dont. Rear doors unable to lock manually by pushing handle in.
Ive stripped the rear door down, put a meter across the pins and when locking / unlocking im only getting 4v.
Where are the relays and which relay controls the CL?
-------------------------------------------------------------------------------
Address 09: Cent. Elect. Labels: None
Part No: 7M3 962 258 AM
Component: Multifunkt.Einh 0003
Coding: 04097
Shop #: WSC 00020
VCID: 0507AFFE1FC8E1095D9-50CE
No fault code found.
2) - Air con
No air con in car, had car regassed, still no aircon, scanned with vagcom and;
-------------------------------------------------------------------------------
Address 01: Engine Labels: None
Part No SW: 03G 906 016 JN HW:
Component: R4 2,0L EDC G000SG 8408
Revision: --H02--- Serial number: VWZ1Z0F2860500
Coding: 0000072
Shop #: WSC 00020 000 00000
VCID: 78F9D60A083A8CE156F-5160
1 Fault Found:
001330 - A/C Refrigerant Pressure Sensor (G65)
P0532 - 000 - Short to GND
Freeze Frame:
Fault Status: 01100000
Fault Priority: 0
Fault Frequency: 1
Reset counter: 255
Mileage: 124942 km
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 12.39 V
Bin. Bits: 11001100
Temperature: 57.6Ã,°C
(no units): 16.0
Readiness: 0 0 0 0 1
Note - its an 2006 (06) alhambra, is this a mk 2 or 3?
welcome5
if it looks like the pic in your profile then its a mk2.
Quote from: gregers on June 06, 2015, 08:59:15 PM
welcome5
if it looks like the pic in your profile then its a mk2.
Its a mk 2 then :D
There is a section in vagcom that will switch the rear doors back on if there has been some sort of glitch. I had it with a vw polo the nearside rear door would not lock. I had all of the door apart and did everything I could to check whether everything was working but using vagcom I just switch it back on and it worked perfectly after that. I'm not saying that is your fault just that it is worth a try getting into that module to see if it is working from there.