Hi boys . Today may car decided not to lock :( . Even turning key did not work (drivers door as well ) . I have tried lock car from inside using button on drivers door but still nothing :'(. VCDS Lite told rear door lock motor intermittent . What is it ? HEEELP
well 1st i would be checking the wires in the door gaitors.
Thanks I will check wiring loom in doors. But problem is away ( not for long I guess ) .
hi mine is the same wires seem to be connected but nothing at all is the a relay fuse that can blow on these??
and if so where do i find it regards
Similar happened on mine.
Remote CL, door switch and sometimes the key would not lock my driver's door but all the others were working ok. The driver's locking seemed to be "Out of sync" with the other doors and eventually, multiple lock/unlocks would render all doors locked but still the door LED wouldn't flash, although the alarm triggered if the door was opened!
The problem was 3 x wires were bared inside the door to door pillar wire loom! Maybe just shorting out? 3 bits of sparky tape and all is working like new. 8-)
hope this helps
Hi all cables look alright. There is no sound coming from the pass front door but does sometimes but still doesn't lock or open my petrol cap isn't unlocking but the boot does weird or what but really need to get it done ASAP if you have any idears please reply thanks
You checked ALL doors including the tailgate for wiring shorts by pulling back the gaitor enough to expose the bend in the wiring yeah?
Yes they seem to be all connected ok. Somebody said the Siemens panel in the. Fuse box can be a bugger
Sent from my iPhone using Tapatalk
The controllers unlikely to be a problem, only really effects the mk1.
You need to check the wiring from the connector back at least 6 inches into the door and the entire length of grommet for the tailgate. Its not that they are connected, its that they arent shorted or broken.
Oh ok. It's an nightmare lol can a faulty door lock modual cause this
Sent from my iPhone using Tapatalk
Hi have had all wire looms out of the doors today. Repaired couple of them. All secure and connected. Still not working.would it be the control panel that is screwed with the fuse box?? Regards
Sent from my iPhone using Tapatalk